TV Mode programming

Discussion in 'W10 GYRO' started by Cerylie, Jun 20, 2019.

  1. Cerylie

    Cerylie New Member


    I was going along fine and programming the TV remote, but now when I try to enter the tb programming mode instead of going from strong to weak to strong it flashes between purple and red and I can't seem to get any of the other steps to work properly either.


    I also can't seem to reset the buttons by following the instructions on page 13
  2. Ken

    Ken Administrator Staff Member

    Are you using new batteries?

    Sorry for replying you late.